Turning On/Off (Local Mode); Season Change - AERMEC GR3 Manuel D'utilisation

Image
SET
R
L
R
C1
C2
Image
SET
R
L
R
C1
C2
DISPLAY OF THE FUNCTIONING PARAMETERS
For displaying operation parameters, the key
SET
the indicator light key
in chapter "SETTING MENU" are displayed. Parameters can be
sequentially displayed by using the arrow keys
writing "Set Setting" appears on the first line and the set value
on the second line.
To change the set parameter, press the key
8
5. TURNING ON/OFF (
6.

SEASON CHANGE

SET
is pressed;
is on and the parameters indicated
+ + e
and the key
Procedure to be adopted
TURNING ON:
For unit commissioning, press only ON key. When the led is on,
the unit is ready for operation.
TURNING OFF:
Turn it off immediately with the same button.
Only if the PR3 accessory is installed, the unit shall be completely
off after seven seconds.
Procedure to be adopted
To activate the season change, just press the key indicated next.
So that the operation is correctly finished, the machine shall be
activated both in remote or in local.
Two symbols are present in the "season change" key:
- The symbol E identifies the heat pump operation;
- the symbol ? identifies cooling operation.
led will also be on. The setting displayed can be modified by using
the arrow keys.
The wording on the first line changes to "Modified Setting". By
. The
pressing the key
using the arrow keys, it is possible to scan set parameters again
to find a new parameter to be changed.
local mode)
again, the modification is saved and, by