Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation page 76

Changing pre-set options
CA
74
(EN)
End of cycle (EOC) beeps
The beeps signalling the end of the cycle can be set to O (no beeps), 5 beeps or 15 beeps. The
default setting is 5 beeps.
To modify the number of beeps sounding at the end of the cycle:
Enter Option Adjustment mode (refer to page 73).
1
Select the HEAVY cycle.
2
Touch the MORE
3
no beeps to sound at the end of the cycle.
Touch POWER to save your settings.
4
Fig.56 Adjusting the end of cycle beeps
Factory reset
You can reset your dryer to the default settings it left the factory with.
To reset your dryer to its factory settings:
Enter Option Adjustment mode (refer to page 73).
1
Select the DELICATE cycle.
2
The display will show "rSt". Touch and hold the START/PAUSE button for three seconds to reset
3
your dryer to its factory settings.
Note: this action will reset the dryer to the default settings, exit Option Adjustment mode and
power off your washer.
Touch POWER to exit if you do not wish to reset your dryer.
Fig.57 Resetting back to the factory settings
Remember, to save changes and exit from the Option Adjustment mode at any time (ie return to
normal operating mode), touch the POWER button.
(or where available) LESS buttons to increase the number of beeps, or for