Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation page 40

Installation instructions
CA
38
(EN)
Adding elbow for exhaust through bottom of cabinet
Insert the elbow section of the duct through the rear opening and connect it to the dryer
internal duct.
Secure the joint between the internal duct and elbow with duct tape, as shown in Figure 28
(page 37).
Fig.30 Exhaust elbow
Complete the exhaust system by connecting the required standard metal elbows and ducts.
Cover the original duct opening at the back with a plate (kit WE1M454, available from Fisher &
Paykel (refer to page 86). Refer to Figure 29 (page 37).
Move the dryer into its final position.
The rear duct opening must be covered with a plate. The dryer must not be operated
without the plate in place.
WARNING!