Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation page 68

Drying cycle options
CA
66
(EN)
Wrinkle Free
Select the WRINKLE FREE if you wish to minimize wrinkling. At the end of
the cycle, the drum will rotate for 30 seconds every 5 minutes circulating
cool air through the load to minimize wrinkling and creasing. This is
particularly useful if you cannot remove the items immediately after the
cycle ends.
WRINKLE FREE can be selected on any cycle (except ENERGY SAVER,
RACK DRY and AIR DRY) and can be turned ON or OFF at any time
during the cycle by touching START/PAUSE, then WRINKLE FREE to OFF.
WRINKLE FREE will operate for a maximum of 24 hours if not stopped
beforehand. To stop WRINKLE FREE at any time touch START/PAUSE, or
open the door. You can then remove your items. Touch POWER to stop
the cycle and turn the dryer off.
After completing each tumble AeroCare will beep to remind you that the load is dry and can
be removed.
Note: WRINKLE FREE is automatically selected on the EASY IRON cycle.
Delay Start (selected models only)
The DELAY START option enables you to delay the start of the drying cycle from between five
minutes and 18 hours. Time delays you can select are 5 mins, 15 mins, 30 mins, 1 hour, and then
hourly up to 10 hours, then for either 12 hours, 15 hours or 18 hours. This can be useful to time
your drying to finish when you arrive home from work, or to start when power rates are lower.
To program a DELAY START, simply touch the DELAY START option button to select ON, then the
MORE button to increase the delay time and LESS
START/PAUSE to confirm your selection and start the countdown. Once started, the time will
countdown on the digital display panel in one minute increments (or one hour increments
when the DELAY START time selected is greater than 10 hours). The START/PAUSE light will stop
flashing and turn on solid. The dryer will tumble periodically during the delay start countdown.
Touch the DELAY START button to turn DELAY START off.
To cancel a delay start time once it is counting down, simply touch START/PAUSE, then touch the
DELAY START button to select OFF to disable the feature. Touch START/PAUSE to start the cycle
immediately.
Note: we strongly recommend that you avoid using DELAY START for damp, non-colorfast items
as this may cause dye to transfer from one item to another.
Fig.52 WRINKLE FREE
option ON
button to decrease the time. Touch