Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation page 44

Installation instructions
CA
42
(EN)
To invert the direction of the door panel, lay the door face down on a safe, protected surface and
5
remove the four screws from the hinges.
Separate the door panel from the inside of the door by removing the six screws, as shown in
6
Figure 36.
Important!
Remove only the six screws as shown.
Lift and rotate the door panel 180º then reinsert the inside of the door in the panel. Replace the
7
six screws removed in Step 6.
Fig.35 Removing screws from the hinges
Fig.36 Separating door panel from inside of door
Fig.37 Rotating door panel, then replacing screws