Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation page 16

Installation instructions
CA
14
(EN)
Connecting a gas dryer (skip for electric dryer)
Refer to page 7 for tools required.
Note: installation and service of this dryer must be performed by a qualified installer, service
agency or the gas supplier.
Gas supply and installation requirements
In the Commonwealth of Massachusetts:
Installation of the dryer must be completed by a plumber or gas fitter licensed by the state.
When using ball-type gas shut-off valves, the t-handle type shall be used.
If using a flexible gas connector, this must not exceed a length of 3 feet in total.
WARNING!
Explosion Hazard
Installations must be performed by a qualified or licensed contractor,
plumber, or gasfitter qualified or licensed by the state, province, or
region where this appliance is being installed.
Use a new AGA or CSA approved gas supply line.
Install a shut-off valve in an accessible place.
Only use a gas shut-off valve approved for use within the state, province,
or region where this appliance is being installed.
Securely tighten all gas connections.
If connecting to LP Gas, have a qualified person make sure gas pressure
does not exceed 13" (330 mm) water column.
Failure to follow these instructions can result in death, explosion, or fire.