Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation page 42

Installation instructions
CA
40
(EN)
Check that the washer inlet hose (which has been removed from the faucet) has a flat washer or
4
filter washer fitted. If not insert a flat washer and connect the hose to one of the male couplings
on the "Y" connector.
Take the long inlet hose and insert a flat washer into the straight female coupling and connect it
5
to the other male coupling on the "Y" connector.
Insert a flat rubber washer into the other female connector and couple the hose to the inlet
6
valve on the rear of the dryer.
Check that all connections are firmly hand tight, then using a pair of pliers tighten each coupling
7
another two-thirds of a turn.
Important!
Ensure you DO NOT OVERTIGHTEN the connections. Overtightening may result in damage to the
couplings.
Check immediately for any leaks from the "Y" connector, hose couplings and/or the faucet. Check
8
again for leaks after 24 hours.
Fig.33 Tightening the connections
Fig.32 Attaching the inlet hose to the dryer