Changing Pre-Set Options - Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation

Changing pre-set options

Option Adjustment mode
In this mode you can modify the number of beeps that sound at the end of the cycle (ie end of
cycle (EOC) beeps), and reset the dryer to the settings it left the factory with (factory reset).
Note: DRYNESS LEVEL and DRYING TEMP settings cannot be modified.
To enter Option Adjustment mode
Turn the machine on at the wall but do not touch the POWER button. Touch and hold the
1
KEYLOCK and START/PAUSE buttons for three seconds. You will hear three quick beeps
indicating you have entered Option Adjustment mode. The diagram below shows how the drying
cycle icons relate to the options you can change. Page 74 explains the options in more detail.
Use the dial and buttons on the control panel to make your changes to the pre-set options.
2
Touch POWER to return to normal mode when you have finished modifying your options. Your
3
dryer will automatically remember your changes.
Adjusting your options
Enter the Option Adjustment mode (refer above).
1
The diagram below shows how the drying cycle icons relate to the options you can change.
2
The two options (the number of end of cycle beeps, and resetting the factory defaults) you can
adjust are accessible using the HEAVY and DELICATE cycles.
Use the MORE (and where available) LESS
3
through the available settings of your selected option.
Fig.55 Option Adjustment mode
Changing pre-set options
buttons underneath the digital display to scroll
CA
73
(EN)