Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation page 26

Installation instructions
CA
24
(EN)
Connecting the dryer using 3-wire connection
Important!
DO NOT use in Canada.
DO NOT use for Mobile home installations, on new constructions, or on recreational vehicles.
NOT for use in areas where local codes prohibit grounding through the neutral conduction.
If required by local codes, install an external ground (not provided) to grounded metal,
a cold water pipe or other established ground as determined by a quali ed electrician.
Green ground screw
Cover
Fig.15 3-wire connections
Turn off the circuit breaker(s) (30 amp) or remove the dryer's circuit fuse at the electrical box.
1
Ensure the dryer cord is unplugged from the wall outlet.
2
Locate and remove the power cord cover at the lower rear of the dryer.
3
Install a ¾" (19 mm) UL-recognized strain relief to the entry hole for the power cord. Move the
4
power cord through the strain relief.
Connect the power cord according to the following:
5
Connect the two hot lines to the outer screws of the terminal block (labelled L1 and L2).
a
Connect the neutral (white) line to the center of the terminal block (labelled N).
b
Ensure the ground strap is connected to neutral (center) terminal of block, and to the green
6
ground screw on located on the cabinet rear.
Tighten all three terminal block screws completely.
7
Correctly secure the power cord to the strain relief.
8
Replace the power cord cover.
9
NEVER leave the power cord cover off the terminal block.
Ground strap
Hot wire
L 1
N
Screws (3) Screws (3)
L 2
Neutral (white) Neutral (white)
¾" (19 mm), UL recognized strain relief
Hot wire
WARNING!
Strain relief bracket
3 #10 awg minimum copper conductors,
or 120/240V 30 amp power supply cord kit
(min length 5 feet (1.5 m)) marked for use with
dryers and provided with closed loop or spade
terminals with upturned ends (not supplied)