Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation page 10

Installation instructions
CA
8
(EN)
Materials:
4" (102 mm) diameter rigid metal duct (recommended).
4" (102 mm) diameter UL-listed flexible metal duct (if needed).
4" (102 mm) diameter metal elbow(s).
Flexible metal gas line connector (for gas connections only).
Duct or spring clamps (2).
Pipe joint compound (pipe dope or tape) for gas pipe connections, resistant to LP Propane,
butane and natural gas (for gas connections only).
Exhaust/vent hood.
Duct tape.
Soap solution for gas leak detection (for gas connections only).
¾" (19 mm) strain relief (electric connections only).
Dryer power cord kit (power cord is not supplied with United States models).
Requirement: UL-rated 120/240 V, 30 amp with 3 or 4 prongs. Identify the plug type needed from
the existing house receptacle before purchasing. Length of cord must be at least 5 feet (1.5 m) long.
To the installer
Read these instructions completely and carefully.
These instructions must be left with the home owner for future reference.
Correct installation is the responsibility of the installer.
Installation of this appliance must be performed by a qualified installer.
The dryer must be exhausted to the outdoors.
Remove the door from an old dryer before it is removed and discarded.
The wiring diagram and service information can be found in the control console.
The limited warranty does not cover product failure as a result of improper installation.
The dryer must be installed in a location where the temperature is above 50°F (10°C) to ensure
suitable operation of the dryer control system.
UL-listed duct material must be used. Discard existing plastic or metal foil duct and replace with
UL-listed duct material.
Observe all governing codes and ordinances.
Follow the installation instructions carefully.
Important!
Save these instructions for local electrical inspector's use.
Observe all governing codes and ordinances.
Install the clothes dryer according to the manufacturer's instructions and local codes.