Switching 12/24H Mode; Switching Between °C/°F Temperature Units - Conrad Profi Mode D'emploi

Then the country and city near which you are located must be entered. These data are needed
to calculate an approximate rising and setting time for sun and moon.
• Briefly push the button „MODE" (B3); the display of the country in which you are located flashes
(see list at the end of these operating instructions).
Set the country with the button „8 (12/24)" (B11) or „2/
• Briefly push the button „MODE" (B3); the display of the city near which you are located flashes
(see list at the end of these operating instructions).
Set the city with the button „8 (12/24)" (B11) or „2/
• Push the button „MODE" (B3) briefly again to save all settings and leave the setting mode
(alternatively, wait for a few seconds without pushing a button).
d) Switching 12h/24h Mode
Briefly push the button „8 (12/14)" to switch between 12h and 24h time display. The weather
station must not be in a setting mode for this.
In 12h mode, „AM" is displayed in the upper left of the display, „PM" during the second half of
the day.
e) Switching between °C/°F Temperature Units
• Briefly push the button „+ (°C/°F)" (B6) at the weather station to switch the temperature unit
between °C (degrees Celsius) and °F (degrees Fahrenheit). The weather station must not be
in a setting mode for this.
• If the temperature unit in the display of the outdoor sensor is switched, open the battery
compartment (D4) of the outdoor sensor, then push the button „°C/°F" (D7) there.
" (B12).
" (B12).
57