Phase Connection Test - LEM SATURN 100 plus Manuel D'utilisation

Measuring

3.4 Phase Connection Test

This mode serves for rapid location of the HI-potential in plug-and-socket systems,
rendering the traditional phase tester redundant. It is not active in switch
positions R ISO , R LOOP (L-N) and R active.
Optimum comfort is obtained if the 3-pin measuring adapter is used.
ATTENTION: To avoid spurious displays, use only the supplied power
cord. Measuring cables from any previous models are not compatible
and must therefore not be used!
Measuring Process:
L1
R
R
B A
Kennung
Gerät
Observe overload capacity and connect instrument as shown.
Turn central selector to any position except R ISO , R LOOP (L-N)
When using the 3-pin plug, make sure that the red marking dot is seen from above
when the plug is inserted.
The following rules then apply if the display shows symbols as below:
HI-potential at left-hand plug pin as seen from the marker
point.
HI-Potential at right-hand plug pin as seen from the marker
point.
L 1
L 2
L 3
L2
L2
N
P E (PEN)
L3
M
L1
L 1 = braun
L 2 = schwarz
L3
L 3 = violett
Gerät
Gerät
and R active.
14