LEM SATURN 100 plus Manuel D'utilisation page 14

Measuring
To start a new measurement, select function and press key
POWER-ON - Normal Operation)
Settings Loop After operating the function selector, the control loop is entered,
where from the complementary values can be called by pressing „DISPLAY".
The following parameters depending on the function can be displayed.
Function: Display:
FI-Test, , U L-PE , U N-PE , Frequency
x5
with probe U L-PE , U N-PE , U S-PE , Frequency
R A U L-PE , U N-PE , U S-PE , Frequency
R ISO , L-PE; N-PE
L-N U L-N , Frequency
R LOOP ,L-N U L-N , Frequency
L-PE U L-PE , U N-PE , Frequency
with probe U L-PE , U N-PE , U S-PE , Frequency
U 1-3 , U 2-3 , Frequency
R U L-N , Frequency
Results Loop This is entered by pressing „START" key. By repeated pressing of
the „DISPLAY" key, all complementary values can be displayed.
Function Display:
FI-Test, , U L ; R S ; t A
x5
with probe U L ; R A ; t A
R A R A
R ISO R ISO , U-discharging voltage
R LOOP L-N, L-PE R S ; I K ; U N
L-PE with probe R S ; I K ; U S-PE ; U N
U 1-3 ; U 2-3 ; Frequency
R R 1 ; R 2 con and 2 Ohm with continuity test, respectively
R
„Start" (see
U L-PE , U N-PE , Frequency
12