Spa Maintenance - Jacuzzi J-500 Manuel D'installation Et Utilisation Et Entretien

Please also see the attached Prolink™ set-up guide.
"Info" menu
This menu shows some of the main hot tub parameters (tem-
perature, etc.).
- From the "Settings" menu, press
rameters (however, no options can be selected).

Spa maintenance

Proper and regular maintenance of your spa will help it retain
its beauty and performance. Your authorized Jacuzzi dealer
can supply you with all the information, supplies, and acces-
sory products you will need to accomplish this.
Information regarding spa cleaning and maintenance and
the products to be used can be found in the catalogue-
guide provided with the product.
I
Cleaning the Filter Cartridges
Reminder
It's time to clean or replace your ProClarity
and ProClear filters. Contact your autho-
rized dealer if new filters are needed.
snooze
reset
A reminder message appears on the control panel display after
a specified number days to remind you to clean the skimmer fil-
ter and to check the polishing bag filter. This reminder must be
reset at each filter cleaning interval. Refer to Section "Water
Care Programming" for additional information and programming
details. Your new spa is equipped with an advanced 2-Stage fil-
tration system. Fine debris are filtered by the circulation pump
drawing water through the ProClarity™/ProClear™ skimmer and
pleated filter cartridges 8 hours (unless programmed otherwise).
Large debris are filtered when jets pump 1 is running when the
spa is in use or during a programmed filter cycle. These pumps
draw water from footwell suction fitting and through a second-
ary water polishing bag filter and additional filter.
I
Cleaning the filters and filter bag
To ensure optimum performance:
The ProClarity™ filter cartridge (A) must be cleaned every month
and replaced every 18 months.
The ProClarity Depth filter (B) must be replaced every 3 months.
The ProClarity filter canister (C) can be rinsed when the filters
are cleaned.
The ProClear II skimming filter cartridge (D) must be cleaned
every month and replaced every 18 months.
The ProClarity debris bag (E) should be checked and emptied
monthly.
To accomplish this, refer to the following filter cleaning proce-
dure.
Note: Do not attempt to wash the ProClarity depth filter (B)
and the ProClear/ProClarity debris bag (E) or it will come
apart!
information
to display the pa-
A
P-r
B
C
P-r: Circulation pump
P-hy: Pump hydro
Do not start the hot tub if the cartridges and filters have not
been installed correctly or if the cover is damaged.
Replacement filter cartridges may be purchased from
your authorized Jacuzzi dealer.
I
Cleaning the filters/Debris bag
A. Turn power to spa off!
B
B. Lift the cover upward to access filter cartridges.
C. Remove the ProClarity debris bag from clips and then clean
out debris.
D. Rotate each filter cartridge handle counterclockwise to
unthread from mating wall fitting. Lift unthreaded filter cartridge
from skimmer well.
1
E
E. Rinse debris from filter pleats using a garden hose and high-
pressure nozzle. Start at the top and work downward towards
handle. Repeat until all pleats are clean.
F. Remove the filter pins (1) in order to separate the ProClarity fil-
ter and canister. Once the filter pins are removed, rotate the filter
cartridge handle counterclockwise to unthread from the filter can-
51
E
D
C
1
1
2
3
F
G
P-hy
D