Spare Parts; Transportation, Storage, Disposal - Burkert BBS-07 Manuel D'utilisation

7. START-UP
WARNING!
Risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the
product and the surrounding area.
• Before start-up, ensure that the operating personnel are familiar
with and completely understand the contents of the operating
instructions.
• Observe the safety instructions and intended use.
• Only adequately trained personnel may start up the equipment/the
product.
• Following assembly, ensure a controlled restart.
• When starting up the equipment, ensure that no unauthorized volt-
age increases and pressure surges can occur.
8. MAINTENANCE
WARNING!
Danger – high pressure and discharge of medium!
• Before loosening the nuts or screws, always turn off the pressure
and relieve the lines/containers.
• Wear protective equipment if media is hazardous.
• Nuts or screws may be retightened on pressurized lines/containers
only by technicians in consideration of special precautions.
• When shutting down the equipment, ensure that no unauthorized
voltage increases and pressure surges can occur.
• Following maintenance, ensure a controlled restart.
Have the product serviced regularly by technicians!
We recommend a maintenance interval of 6 months.
Inspection and maintenance work includes in particular monitoring and
ensuring the
• leak-tightness,
• identification,
• proper mode of operation of the safety and warning devices.
8
10. TRANSPORTATION, STORAGE,
DISPOSAL
NOTE!
Transport damage!
Inadequately protected products may be damaged during
transportation.
• Transport the product in a firmly assembled state, protected against
moisture and dirt, in shock-resistant packaging.
Incorrect storage may damage the product.
• Prevent the temperature from exceeding or dropping below the
permitted storage temperature.
• Store the product in a dry and dust-free location!
• Store O-rings dry and protected from UV radiation and for not
longer than 3 years.
• Storage temperature -40 to +80 °C.
Damage to the environment caused by products contaminated
with media.
• Dispose of the product and packaging in an environmentally friendly
manner!
• Observe applicable disposal and environmental regulations.
english
NOTE!
Damage to the sealing elements when cleaning the system.
• Clean the system preferably with a cleaning agent which does not
damage the sealing elements.
• Do not clean with wire brushes or machines which cause abrasion
of the surface.
• When using mechanical pipeline monitoring devices, ensure
that they do not damage the sealing elements (also the sealing
contour).
Damaged sealing elements must be replaced!
english
9.

SPARE PARTS

CAUTION!
Risk of injury and/or damage by the use of incorrect parts!
Incorrect accessories and unsuitable spare parts may cause injuries
and damage the product and the surrounding area.
• Use only original accessories and original spare parts from Bürkert.
The spare part set for Type BBS-07 tank flange contains: O-ring
The spare part set for Type BBS-07 tank flange with inspection glass
contains: O-ring, glass
The order numbers for the spare part sets can be found on the corre-
sponding data sheet on the Internet.
english
7
9