Maintenance Work; Spare Parts; Disassembly; Transportation, Storage, Disposal - Burkert 2101 Manuel D'utilisation

9

MAINTENANCE WORK

→ Perform a visual inspection of the device once per year. Shorter
maintenance intervals are recommended depending on the
usage conditions.
Visual inspection:
According to the usage conditions, perform regular visual
inspections:
→ Check medium ports for tightness.
→ Check relief bore on the pipe for leaks.
Fig. 10: Relief bore
9.1

Spare parts

CAUTION!
Risk of injury and/or damage due to incorrect parts!
Incorrect accessories and unsuitable spare parts may cause injuries
and damage the device and the area around it.
▶ Use only original accessories and original spare parts from
Bürkert.
Wearing parts: Seals and swivel plate.
→ If leaks occur, replace the respective wearing part.
The maintenance and repair instructions can be found
online at: www.country.burkert.com
Type 2101
Start-up
Relief bore
10

DISASSEMBLY

DANGER!
Risk of injury from high pressure in the system!
▶ Before loosening lines or valves, switch off the pressure and
bleed the lines.
Risk of injury from electric shock!
▶ Before reaching into the device or the system, switch off the
power supply and secure to prevent reactivation!
Procedure:
→ Disconnect the pneumatic connection.
→ Disassemble the device.
11 TRANSPORTATION, STORAGE,
DISPOSAL
NOTE!
Damage from transport and storage!
• Protect the device against moisture and dirt in shock-re-
sistant packaging during transportation and storage.
• Storage temperature –20 – +65 °C.
Damage to the environment caused by device parts contam-
inated with media.
• Dispose of the device and packaging in an environmentally
friendly manner!
• Observe applicable disposal and environmental regulations.
English
17