Operating The Dishwasher; Additional Features; Delay Start - Thermador DWHD640JFM Guide D'utilisation Et D'entretien

Operating the Dishwasher

Start the dishwasher
Open the door and press the ON/OFF button. The dishwasher automatically resets to the Auto cycle and the
1
time displayed flashes.
Select a different cycle or keep the same and select desired options.
2
Press START and close the door to begin the cycle.
3
Interrupt a cycle
Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
1
Press the ON/OFF button to turn the unit off.
2
Wait at least 10 seconds before fully opening the door.
3
To resume the cycle, press the ON/OFF button and close the door.
4
Cancel a cycle
Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
1
Press and hold START for approximately 3-4 seconds until the display indicates "0:01".
2
Close the door and wait about 1 minute while the dishwasher drains.
3
Open the door and press the ON/OFF button. You may now start a new cycle by turning the dishwasher back
4
on and following the "Start the dishwasher" instructions above.
Using the Star Speed™ cycle (DWHD651Jxx only)
Open the door and press the ON/OFF button.
1
Select the cycle button. The dishwasher should be empty and without detergent for the preheating period.
2
Press START and close the door to begin preheating. The Time Remaining PowerBeam® will show an "H"
3
alternating with the time remaining for preheat. Once the time remaining counts down to "0:00" the Time
Remaining PowerBeam® will turn off.
Open the door at any time to begin loading dishes for first Star Speed™ wash. The Time Remaining Power-
4
Beam® will show an "L" during the loading period.
Add detergent, press START and close the door.
5
The Time Remaining PowerBeam® will now show "TURBO SPEED" alternating with the time remaining (starting at
6
20 minutes).
When the cycle is done, the Time Remaining PowerBeam® will turn off.
7
The next Star Speed™ wash cycles can run without any preheating (maximum of 60 minutes in between cycles).
8

Additional Features

Delay Start

You can delay the start of the cycle in one hour increments up to 24 hours.
Open the door and press the ON/OFF button.
1
Select a cycle and desired options.
2
Press the Delay + button until the display shows "h:01" = 1 hour up to "h:24" = 24 hours (for DWHD640Jxx
3
and DWHD650Jxx models) or "1" = 1 hour up to "24" = 24 hours (for DWHD651Jxx models).
Press the + or - buttons until the display corresponds with your requirements.
4
Press START and close the door. The delay is now activated.
5
To cancel delay start:
Open the door and press the + or - buttons until the display shows "h:00" (for DWHD640Jxx and DWHD650Jxx
1
models) or "0" on the right side of the display (for DWHD651Jxx models).
Close the door and cycle will begin.
2
Cycle Completion Signal
The cycle completion is indicated by a tone.
To change setting:
Open the door and press the ON/OFF button.
1
Hold down the A button and press and hold START until the display indicates "H:00".
2
Release both buttons. The LED for the A button flashes and display indicates "H:00".
3
Press the A button until the display shows "b:02" (factory setting or your previous setting).
4
Press the C button to increase or decrease the tone "b:00" = OFF and "b:03" = loudest and press START
5
to save the setting and close the door.
15