Thermador DWHD640JFM Guide D'utilisation Et D'entretien page 19

Time Remaining PowerBeam® * (DWHD651Jxx only)
Our Star-Sapphire® dishwashers offer a convenient Time Remaining PowerBeam® light that projects cycle status
and time remaining on the kitchen floor (all other models offer our blue PowerBeam® light to let you know the unit
is running).
Note: If the appliance is installed at eye-level, the time remaining information is not visible.
S:01 default setting:
In the default setting (S:01) the time remaining, selected cycle, delay start time and water intake testing are indi-
cated. Example: If you select a cycle and start your dishwasher in the S:01 (default) setting, the time remaining
image will display in rotation with the selected cycle image (about 5 seconds per image).
S:02 setting:
In the S:02 setting the time remaining image, selected cycle image, delay start time and water intake testing are
indicated along with other images - see below. Example: If you select a cycle and start your dishwasher in the S:02
setting, the time remaining image will display in rotation with the selected cycle image and any applicable extra
info images (about 5 seconds per image).
Time remaining image
To change setting:
Open the door and press the ON/OFF button.
1
Hold down the A button and press and hold START until the display indicates "H:00".
2
Release both buttons. The LED for the A button flashes and display indicates "H:00".
3
Press the A button until the display shows "S:01".
4
Press the C button to switch between "S:00" = OFF, "S:01" = default and "S:02" = extra info displayed
5
Press START to save the setting and close the door.
6
All time remaining images (shown in S:01 and S:02 setting):
All selected cycle images (shown in S:01 and S:02 setting):
Pots & Pans
(see next page for more images)
Time remaining image
Selected cycle image
Pre-rinse Cleaning
Auto Normal
Selected cycle image
Time remaining image
Rinse aid
Hand Wash Star Speed
Extra info image
Drying
Rinse
17