Intensive Drying
The final rinse uses a higher temperature which improves the drying result. The running time may increase slightly.
Use caution if utensils are delicate!
To change setting:
Open the door and press the ON/OFF button.
1
Hold down the A button and press and hold START until the display indicates "H:00".
2
Release both buttons. The LED for the A button flashes and display indicates "H:00".
3
Press the A button until the display shows "d:00"(factory setting or your previous setting).
4
Press the C button to turn on intensive drying "d:01" = ON and "d:00" = OFF and press START to save the
5
setting and close the door.
Sapphire Glow® *
The interior light comes on when the door is opened, even if the unit is powered off. When the door is closed or
slightly ajar, the interior light is off.
To change setting:
Open the door and press the ON/OFF button.
1
Hold down the A button and press and hold START until the display indicates "H:00".
2
Release both buttons. The LED for the A button flashes and display indicates "H:00".
3
Press the A button until the display shows "P:00" (factory setting or your previous setting).
4
Press the C button to switch between "P:00" = ON and "P:01" and "P:02" = OFF and press START to save
5
the setting and close the door.
PowerBeam® *
An LED illuminates the floor to indicate the unit is running. Do not open the dishwasher door until the LED is no
longer visible on the floor.
Note: If the appliance is installed at eye-level, the LED is not visible.
To change setting:
Open the door and press the ON/OFF button.
1
Hold down the A button and press and hold START until the display indicates "H:00".
2
Release both buttons. The LED for the A button flashes and display indicates "H:00".
3
Press the A button until the display shows "I:01"(factory setting or your previous setting).
4
Press the C button to switch between "I:01" = ON and "I:00" = OFF and press START to save the setting
5
and close the door.
*
model dependent (see page 4)
16