Operating The Dishwasher - Thermador DWHD630GCP Guide D'entretien Et D'utilisation

10

Operating the Dishwasher

To begin a cycle:
Open the dishwasher door.
Press the ON button to turn unit on.
Select a wash cycle.
Close the door to begin cycle.
To interrupt a cycle
1. Open the dishwasher door just far enough to expose
the control panel.
2. Press the ON/Of button to turn the unit of.
3. Wait at least ten seconds or until the water noises
stop before opening the dishwasher door.
4. To resume the cycle, press the On/Of button and
close the dishwasher door.
Canceling or changing a cycle
To cancel or change a cycle, open the dishwasher door
far enough to expose the control buttons then press and
hold the "Cancel Reset" buttons for 3 seconds.
Close the door and wait until the dishwasher completes
the cycle (approx. 1 min). Open the door and press the
ON/OFF button. You may now begin a new cycle.
WARNING
You could be seriously scalded if you allow hot water
to splash out of the dishwasher. OPEN THE DOOR
CAREFULLY during any wash or rinse cycle. Do not
fully open the door until water noises have stopped.
Cancel / Reset
Dishware Drying
At the end of the cycle the dishwasher will stop and a
period of condensation drying will follow. After drying,
the cycle is complete and depending on your model:
the "Clean" light will illuminate OR
the cycle completion signal will sound OR
the countdown display will show "0" OR
When the cycles are complete, the "Sanitized"
indicator on your dishwasher control panel will
illuminate. However, if your household water supply
is to hot your dishwasher's heating time may be
reduced, and the Sanitized indicator may not show.
19