Operating The Unit - Thermador DWHD650G Série Instructions D'installation

Operating the unit

Turning on the appliance
• Open the door.
Turn unit on by pressing [ON/OFF]. The LED of the last selected cycle lashes.
•
(For DWHD651Gxx models, press ON/OFF irmly.)
• You may select a diferent cycle or keep the same.
• Press [START].
• Close the door. The selected cycle starts running.
Interrupting the cycle
• Open the door.
• Press [ON/OFF]. The LEDs will go out. The cycle is saved. If the door was opened on an appliance which has a warm
water connection or is heated, irst leave the door ajar for several minutes and then close. Otherwise, expansion
(pressure) may cause the appliance door to spring open or water to run out of the appliance.
• To continue the cycle, press [ON/OFF] again.
• Close the door.
Cancelling or changing the cycle
• Open the door.
• Hold down the "A" button and press [START] for approximately 4 seconds until "0:01" is lashing on the display .
• Close the door. The cycle will run for approximately 1 minute.
• Open the door.
• The display will indicate "0:00".
• Press [ON/OFF].
• Close the door.
Sapphire Glow ™ Light *
The interior light comes on when the door is opened regardless of whether the unit is powered ON or OFF.
When the door is closed or slightly ajar, the light is of.
To change setting:
• Open the door.
• Turn on by pressing [ON/OFF].
• Hold down [NORMAL] and press and hold [START] until "H:00" is indicated on the digital display.
• Release both buttons.
• The LED for [NORMAL] lashes and the display shows "H:00".
Press [NORMAL] until the display shows "E:01".
•
• Press [QUICK CLEAN] to turn the interior light of "E:00" or on "E:01".
• Press [START] to save setting and light will turn of or on.
• Close the door.
* model dependent
18