Operating The Dishwasher - Thermador DWHD410JFM Guide D'utilisation Et D'entretien

Operating the Dishwasher

Start the dishwasher:
Open the door and press the ON/OFF button.
1
Select a cycle and desired options.
2
Close the door to begin the cycle.
3
Delay start:
Open the door and press the ON/OFF button. Select a cycle.
1
Press and hold the Delay start button. Release when the desired delay time is shown in the display window.
2
Close the door to begin the cycle.
3
Cancel a cycle:
Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
1
Press and hold the two buttons labeled CANCEL/RESET for 3 seconds.
2
Close the door and wait about 1 minute while the dishwasher drains.
3
Open the door and press the ON/OFF button. You may now start a new cycle.
4
You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CAREFULLY
during any wash or rinse cycle. Do not fully open the door until water noises have stopped.
Interrupt a cycle:
Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
1
Press the ON/OFF button to turn the unit off.
2
Wait at least 10 seconds before fully opening the dishwasher door.
3
To resume the cycle, press the ON/OFF button and close the dishwasher door.
4
Added heat for drying:
Press and hold the Auto button, then press and hold the ON/OFF button.
1
When the LED display window indicates a "0" or "1" release both buttons.
2
To activate the added heat for drying, press the Auto button until the display indicates "1".
3
To disable the added heat for drying, press the Auto button until the display indicates "0".
4
Press the ON/OFF button to save the setting.
5
Cycle completion signal:
The cycle completion signal alerts you when a cycle completes and the dishwasher has washed and dried the dishes. You
can choose to disable the tone or adjust the volume. The dishwasher must be powered OFF before adjusting the signal.
To activate:
With the unit OFF, press and hold the right of the two CANCEL/RESET buttons and then press and hold the ON/OFF
1
button.
When the light on the CANCEL/RESET button you are pressing illuminates and the tone goes off, release both buttons.
2
Press the right of the two CANCEL/RESET buttons again until you achieve the desired volume or until there is no tone
3
(to turn cycle completion signal OFF).
Press the ON/OFF button to save the setting.
4
WARNING
11