Night Light Tm Replacement; Bulb Replacement; Lens Assembly Installation; Lens Assembly Replacement - Napoleon GD19-1N Instructions D'installation Et D'opération

50
12.4 NIGHT LIGHT
12.4.1

BULB REPLACEMENT

EN
The GD19 comes equipped with our "Night Light™". If in the event the lamp or lens needs to be replaced, follow
these instructions.
Turn off all electrical supply.
A.
Remove the safety screen, front and door from the fi rebox.
B.
Unscrew the lens cover making sure the washer stays in place.
C.
NOTE: Do not handle the lamp (bulb) with bare fi ngers, protect with a
clean dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel Ltd. parts
D.
only (W387-0009), as lamp and lens are special "high temperature" products.
Replace lens with gasket, lens covers, attach wires to quick connects and replace the safety scrren and
E.
door when fi nished.
NOTE: The fi rebox must be sealed.
When re-assembling the light assembly, care must be taken. "Light Leakage" from above the cast doors
may be noticed. The holes in the lamp housing are necessary for ventilation and must not be covered.
12.4.2

LENS ASSEMBLY INSTALLATION

Remove the safety screen and door from the fi rebox.
A.
Run the wires up through the lens hole.
B.
Align key hole with lens assembly.
C.
Snap into place.
D.
Replace light shields, attach the wires and replace the door to the fi rebox.
E.
12.4.3

LENS ASSEMBLY REPLACEMENT

Remove the safety screen, front door and top shield from the fi rebox.
A.
Compress the retainer fi ns in with a screw driver while pressing fi rmly on
B.
the top of the light assembly.
Once all the retainer fi ns are pushed in the lens assembly will snap out of
C.
place.
W415-1351 / 08.29.14
REPLACEMENT
TM
KEY HOLE