Night Light™ Replacement - Napoleon STARfire Serie Mode D'emploi

maintenance
EN
10.7 night light™ replacement
Your HDX35 comes equipped with a "Night Lights™". The light has been pre-wired and is controlled from the
remote control.
If in the event the lamps or lens need replacing, follow the instructions below:
A. Shut off breaker at main power supply
B. Remove the four screws that secure the lens frame to the
fi rebox top. This frame retains the glass lens.
C. The lamp can now be accessed.
note:
Do not handle the lamp (bulb) with bare fi ngers. Protect them with a clean, dry cloth. The lamp will pull straight
out of the socket. Replace with Wolf Steel parts only, as lamp and lens are special "high temperature" products.
When reinstalling, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens. "Light Leakage" from the holes in the housing lamp
may be observed. The holes in the lamp housing are necessary for ventilation and must not be covered.
50
W415-2372 / A / 11.14.19
LENSE GASKET
FRAME