Check Weighing Function; Hold Function Mode; Selection Of Weighing Units - Adam Equipment LATITUDE LBX 3 Mode D'emploi

6.6 CHECK WEIGHING FUNCTION

•
Press [FUNC/ ↑ ] to switch on or off this function.
•
"CHK of"：check weighing function is off.
•
"CHK on"：check weighing function is enabled.
•
Press the [Tare/↵] key to confirm and move to the next setting. The hold
function mode has been entered when "HOD on" or "HOD of" is displayed.

6.7 HOLD FUNCTION MODE

•
Press [FUNC/ ↑ ] to change the state of the function.
•
"HOD of"：Hold function is off all the time and not available to the user to
set as in section 5.3.4.
•
"HOD on": Hold function is enabled.
•
Press [Tare/↵] to confirm and move to the next setting.
•
The selection of weighing units setting has been entered when "On g " or
"OFF g" is displayed.

6.8 SELECTION OF WEIGHING UNITS

Each weighing unit can be set to be either on or off. If it is on it is available when the user
presses the [UNITS/ → ] key during normal weighing. If it is off the weighing unit is not
available during normal use. The kilograms unit is always on.
•
Press the [FUNC/ ↑ ] key to change the unit from on to off.
•
On: the unit is enabled.
•
Off: the unit is disabled.
•
The units will be in the following sequence: "g"/ "lb" / "oz"/"LB: OZ".
•
Press the [Tare/↵] key to confirm and move back to the first setting.
Press [ZERO] to escape the function menu and enter the normal weighing mode to save
the changes you made.
© Adam Equipment Company 2020
9