Parameters; Check Weighing Parameters - Adam Equipment CBK Serie Mode D'emploi

EN
4.0

PARAMETERS

Pressing the [Func] key allows the user to access the parameters for customising the scale. The parameters
are split into 3 groups- Check weighing parameters, RS-232 parameters and Scale parameters. Please find
the RS-232 parameters in complete manual.
When [Func] is pressed, display will first show
parameters or [3] for Scale parameters or press the [Func] key to advance through the groups
"FUnC 2" "FUnC 3"
and . Press [Tare] to enter the desired group of parameters.
Press [Zero] to return to the group
section and return to normal weighing.
4.1.

CHECK WEIGHING PARAMETERS

Shortcut to enter this group is to press and hold the [Func] key for 4 seconds. The display will go directly to
"FUnC 1".
Press [Tare] to enter the group. Press [Func] to view the options for setting. Press [Tare] to
confirm the change and then advance to the next parameter by pressing the [Func] key.
Parameter Description
F1 PCt This parameter allows the user to
enter the Percent weighing Function.
See Section 10.7.
F2 LLk This parameter prevents the normal
user from changing the limits with the
help of a Limit Lock.
F3 LEd This
indicator to off or on and the LED
type (whether LED's are on in the
form of a continuous bar or a spot
LED).
This parameter sets the Beeper to off
F4 bEP
or on. If set to on, the beeper can
further be set to sound when the
weighing result is within or outside
the check-weighing limits.
This parameter allows setting of a
F5 CPS
new Check weighing password, must
(Not available
be entered twice when asked. When
in CBK-M)
complete, it will display "donE".
F6 Nck This parameter enables negative
check weighing function with ability to
(Not available
do negative tare.
in CBK-M)
NOTE:
The Check weighing password is separate from the scale password, If the password is other than
0000, user must enter the password to gain access to
and "F6 nCK".
© Adam Equipment Company 2017
"FUnC 1"
"FUnC 1"
. If you press [Zero] again, the scale will exit the User Parameter
parameter sets the
8
for Check weighing parameters. Enter [2] for RS-232
Options
None
With LLK set to Off (oFF), the
user is allowed to change limits
at any time.
With LLK set to Preset (PSt), the
user is allowed to use one of the
preset limits only.
bAr
LED
- Bar type
Spot - Spot type
oFF
- Off
bP oFF - Off
bP inL - Within limits
bP otL - Outside limits (>20d)
To be entered manually.
on
oFF
"F2 LLk", "F3 LEd", "F4 bEP", "F5 CPS"
"FUnC 1",
Default
setting
Enabled
always
oFF
bAr
bP inL
0000
on