Steps = Check-Weighing Function (Low-Ok-High) - Adam Equipment AELP Notice Utilisation

StEPS = CHECK-WEIGHING FUNCTION (LOW-OK-HIGH)

6.7
• The check-weighing function will show a symbol on the left side of
the display to indicate if the current weight displayed is:
• To enable the check-weighing function and set the value of the
setpoints press the [Func] key until "StEPS" is displayed.
• Press [Print] to enter the function. The display will then show all
zeros and the left most digit will be flashing. The LOW
symbol will be on.
• Use the [Tare] key to set the digit to be changed and the [Print]
key to set the value for the low setpoint. When the value is correct
press [Func] to go to the high setpoint.
• Set the high setpoint and press [Func] to return to weighing.
• The display will indicate when the weight shown is below the low
setpoint, between the setpoints or above the high setpoint.
• To disable the function press the [Func] key until either "PIECE" or
"StEPS" is displayed and then press the [Tare] key.
© Adam Equipment Company 2005
- above the High setpoint
- between the setpoints
- below the Low setpoint
12