5.2
WEIGHING
•
Press
revision. Then it will begin its self-checking test from 9 to 0. When reading is
stable, the display will show "", stable symbol, zero symbol, and the
weighing unit used the last time the scale was used.
•
Press and hold [FUNC/ → ] until ''S1 Un'' will be displayed then press
to confirm selection and use [Tare/ ↑ ] key to select units from "kg" / "g" /
↵]
"lb" / "oz"/"lb:oz".
•
Press
•
Check if the reading is "", if not, press [
will be displayed.
•
Put the item to be weighed on the pan. When the reading is stable, the gross
weight will be shown.
If a container is used, put the container on the pan and press the [Tare/ ↑ ] key when the
reading is stable. The display will show "", the zero symbol and 'NET'. Load the container
or remove material from the container, the scale will show the net weight of the material
added or removed.
5.3
USER FUNCTIONS
The check weighing, parts counting and percent weighing functions can be accessed
using the [FUNC/ → ] key.
5.3.1 CHECK WEIGHING
•
When in normal mode, press [FUNC/ → ] and the display shows "F1 CHK".
•
Press
one digit flashing and the 'HI' LED lit.
•
Press [Tare/ ↑ ] to increase the flashing digits;
•
Press [FUNC/ → ] to select the digit;
© Adam Equipment Company 2020
/Esc to turn on the scale. The display will show the software
/Esc to return to normal weighing.
to set the high limits. The display will show the "000000" with
[0/ ↵]
↵
]. "" and the zero symbol
0/
[0/
5