Maintenance/Verification; Information About Maintenance And Verification; Check Content Of Calibration Counter - Seca 704 Mode D'emploi

Malfunction
... when the Enter key
(send/print) is pressed
Er:X:72
and
played?

10.MAINTENANCE/VERIFICATION

10.1 Information about maintenance and verification

10.2 Check content of calibration counter

Data transmission not possible, no wireless group
set up.
is dis- - Set up wireless group (see "Set up wireless
group (Lrn)" on page 59).
We recommend having maintenance performed prior
to verification of the scales.
Ensure that verification is carried out by authorised per-
sons in accordance with the national legal require-
ments.
Verification is required in all cases if one or more cali-
bration seals have been damaged or the content of the
calibration counter does not match the number on the
valid calibration counter sticker.
These seca scales have been verified. Calibration may
only be performed by authorised bodies. To ensure
this, the scales are equipped with a calibration counter
which registers every change in data relevant to
calibration.
If you wish to check that the scales are properly veri-
fied, proceed as follows:
1. Switch the scales off if necessary.
2. Hold down any key and start up the scales.
The current content of the calibration counter will
flash in the display for a few seconds.
Cause/Remedy
ATTENTION!
Incorrect measurement due to improper
maintenance
– Make sure that maintenance and repair are
only carried out by an authorised service
partner.
– You can find your local service partner at
www.seca.com or just send an e-mail to
service@seca.com.
Maintenance/Verification • 65
English