Installing Sensor And Magnet Ring (Rotary Motion) - Balluff BML-S1C0-Q53-M400-0-KA Serie Mode D'emploi

BML-S1C0-Q53_-M400-_0-KA_ _
Magnetic Linear Encoder System
3 Sensor Installation (cont.)
Fitting the sensing head
The sensor head should be secured
with M3 screws, with its right or left
side against the machine part
whose position is to be determined.
Important!
No forces allowed on the housing
cable. Provide strain relief for the
cable.
3.2 Installing sensor and magnet rings (rotary motion)
Important installation
notes:
The permissible distance and angle
tolerances as per Figs. 3-5, 3-6 and
3-7 must be strictly observed.
The sensor head must not be
allowed to touch the magnet ring.
The magnetic tape must not be
subjected to strong external
magnetic fields.
Fig. 3-5: Permissible gap
Recommendation for selecting
the tape
Magnetic tape BML-M02-I46 or
magnet rings
Direct contact with holding soleno-
ids or other permanent magnets
must be avoided.
The displacement measurement
system must be installed in
accordance with the specified
enclosure rating.
Rear view
Front view
with cable
Incremental
sensors
Fig. 3-6: Permissible tangential offset
Note:
For a detailed technical description
and installation instructions for
tapes, see User's Guide for tape at
www.balluff.com
The sensor can be installed with the
cable entry to the right or left with
respect to the magnet ring (Fig. 3-
6).
Note:
For a detailed technical description
and installation instructions for
magnet rings, see User's Guide at
www.balluff.com
Fig. 3-7: Permissible tangential offset
english
5