Exchanging Milling Cutter And Scanner; Adjust Tool Length - Amann Girrbach ceramill multi-x Mode D'emploi

3. „Off" button engaged: The vacuum is completely turned off.
Recommended after completion of work. Activation of vacuum
by engaging the pedal.
Setscrew on the lower side of the foot switch for adjust-
ment of the vacuum:
The factory default air pressure for loosening and fixating the
spherical shell table has been set to an optimum and should
therefore not be changed. If adjustment of the air volume
should nevertheless be necessary, it is possible to regulate
pressure via a knurled screw on the lower side of the foot
switch. (Turn right to increase, left to decrease air volume).
6. exChangIng MILLIng
CUtter anD SCanner
Inserting and exchanging of milling cutters and scanners is
performed using the collet locks. It is imperative to switch off
the motor. To guarantee the precision of the machine and the
optimal processing of the blank forms, only use original
Ceramill Roto tools by AmannGirrbach. Procedures and strate-
gies for processing the zirconium dioxyde blank forms can be
learned from the training documents for the Ceramill system.
Upgrade kit Multi-x
6.1

aDJUSt tooL Length

Insert a tool pair (such as T/F3) into the hand-pieces (scanner
left, milling cutter right). To this end, open the collet lock BS of
the respective handpiece, insert the tool up to the stop and
close the collet lock again.
Generally: Tool lengths are adjusted ALWAYS on the spherical
shell surfaces, NOT on the calibration or mounting plates
(see image).
After insertion of the tools, open the Allen screw or knurled
screw, respectively, at the scanner handpiece.
Lower the scanner handpiece in the mounting down to the
stop.
U S e r M a n U a L
gB
33