Amann Girrbach ceramill multi-x Mode D'emploi page 27

InDex
1. Description of parts Ceramill Multi-x
2. Product description
3. Commissioning
4. assembly
4.1 Dismantling of the base table unit and installation of the spherical shell table
4.2 Dismantling of the base milling/sensing unit and installation of the vertical pantograph
4.3 Connection of the foot switch for controlling the compressed air
4.4 Resetting/Assembling the extractor dish
4.5 Setscrews for regulation of pressurized air stream
4.6 Electricity supply
4.6.1 Switching between voltages
4.7 Aspiration unit
5. Function of the foot switch
6. exchanging milling cutter and scanner
6.1 Adjust tool length
7. Calibration of the device (adjusting the magnification factor)
7.1 At the guide skid
7.2 Micrometer screw
7.2.1 Handling the micrometer screw
7.3 Table
8. Spirit level
8.1 Adjust the device for manufacturing abutments
9. Control and adjust of the Ceramill Multi-x Upgrade kit
9.1 Control of the Upgrade Kit
9.2 Adjustment of the Upgrade Kit
10. operation and handling of blank forms and fastening plates
10.1 Inserting the fastening plate and blank forms into the mounting plates
10.2 Inserting and turning the mounting plates
10.3 Tilting the spherical shell table
11. Maintenance/care
11.1 Cleaning and maintenance of the scanning and milling heads (handpieces)
12. warning and safety instructions:
13. technical data
14. accessories / Components
15. Packing list
Upgrade kit Multi-x
U S e r M a n U a L
26
28
28
28
28
29
30
31
32
32
32
32
32
33
33
34
34
35
36
37
39
40
40
41
42
43
43
44
44
44
45
46
46
46
47
gB
27