Dismantling Of The Base Milling/Sensing Unit And Installation Of The Vertical Pantograph - Amann Girrbach ceramill multi-x Mode D'emploi

Tighten the screws with the Allen wrench supplied. The adapter
is conceived in such a manner that it remains mobile in spite of
the screws being tightened. CaUtIon! Take care that the
guide rail runs smoothly!
Set the spherical shell table $ onto the adapter and mount
with the CL screw supplied using the Allen wrench. As soon as
the screw is tightened, the table should not demonstrate any
more play.
Subsequently, the spherical shells should be inserted carefully
using both hands.
Upgrade kit Multi-x
Adapt the balancing weight DP ,as needed, to suit the clamp
lever on the back. Through the balancing weight, the spherical
shells remain in balance even when the vacuum is
switched off.
4.2 DISMantLIng oF the BaSe MILLIng/
SenSIng UnIt anD InStaLLatIon oF the
vertICaL PantograPh
Remove the handpieces and the blowout nozzle and put
them aside.
Detach the screw from the assembled milling unit and remove
the milling unit from the base plate.
U S e r M a n U a L
gB
29