Resetting/Assembling The Extractor Dish - Amann Girrbach ceramill multi-x Mode D'emploi

Insert the end of the hose, to which the T-piece is connected
(B), to the foot switch for the compressed air supply DT
located on the back of the device.
Connect the other end of the hose (A) to the right side of the
base of the spherical shell table CO . Insert the hose as far as
possible into the bore hole.
Connect the compressed air hose, which is included, to the
source of air on your work station. Turn the compressed air on.
attentIon! Compressed air must be dry and free of oil!
Use a pressurized air filter if required.
Upgrade kit Multi-x
4.4 reSettIng/aSSeMBLIng
the extraCtor DISh
Remove old vacuum hose and end of old hose CP and replace
with longer vacuum hose.
Mount the longer siphon tubing ...
... and connect to the siphon adapter.
U S e r M a n U a L
gB
31