Checking/Reloading Battery Of Receiver Collar; Changing The Contact Points - Num'axes CANICOM 300 Expert Guide D'utilisation

Replace the battery as follows:
- On the back of the remote control, unscrew the screw and remove the battery cover (ref. Diagram 6).
- Remove the old battery.
- Insert the new battery (3-V Lithium CR2) paying attention to follow polarity indicated on the battery
housing.
- Put the battery cover back in place and retighten the screw.
- Check the remote control operates correctly.

Checking/reloading battery of receiver collar


To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
− battery sufficiently charged: flashes slowly green
− weak battery: flashes quickly green
When the battery is too weak, the product switches to safety mode and the system locks up.
Recharge the battery by following the procedure indicated above, at the beginning of this user's guide
(See § Charge of the CANICOM Expert collar).

Changing the contact points


Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit.
Carefully tighten them manually (do not use a key).
You can purchase extra-long contact points from your supplier at any time.
Gb - 28
Diagram 6
Replacing battery of
CANICOM 300 Expert
remote control
WARNING
Make sure the
polarity is correct