Checking/Replacing Battery Of Receiver Collar; Changing The Contact Points - Num'axes CANICOM 200 First Guide D'utilisation

« + » of the battery
must be visible
When the battery is empty, you can not use the remote control. If pressing a button, the LED located on
the front of the remote control will not light.

Checking/Replacing battery of receiver collar

To check the condition of the receiver collar battery, observe the indicator light located on the front of the
receiver collar:
• Battery fully charged: flashes slow green.
• Weak battery: flashes quickly red. Replace it with a new battery 3-V Lithium CR2 (See § Fitting the
battery in the receiver collar). Check the receiver collar operates correctly.

Changing the contact points

Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).
Gb - 26
Diagram 5