How To Check That Your Canicom 300 Expert Is Functioning Properly; Getting The Best Results; Fitting The Collar - Num'axes CANICOM 300 Expert Guide D'utilisation

How to check that your CANICOM 300 Expert is functioning properly


You can check that your CANICOM 300 Expert is operating correctly at any time.
- Before doing so, make sure that the receiver collar is turned "Off" (indicator light off).
- Fix each wire of the neon test lamp under each contact point (unscrewing them lightly and retightening
them so as to pinch the test lamp wires under the contact points).
- Turn "On" the remote control and receiver collar you want to test.
- Select the receiver collar you want to test on the remote control:
Press the A or B key in order to select the collar (the letter A or B will appear on the LCD screen).
- Press the F or C button and modify the level of intensity of the stimulations: the test lamp will come on
with more or less intensity.
Renew the same procedure for each receiver collar you want to test.

Getting the best results


The training instructions you send to your dog are sent from the remote control to the receiver collar(s)
by radio waves.
These radio waves are sensitive and the range reaches approximately 300 meters (depending on geography
and environment).
The performances of your product will be optimal if you follow these recommendations:
- To obtain a good radio range, do not cover the antenna when you hold the remote control in your hand.
- The position of the receiver collar around the neck of the dog should be in the following way: the On/Off
indicator light on the collar is visible and is not in contact with the breast of the dog.
- Check the batteries (remote control and receiver collars) before using the unit and replace or recharge
them as soon as the level of load is weak.
- The performances of the batteries decrease slightly under temperatures lower than 0°C. If possible, keep
the remote control warm (e.g. inside a pocket) before using it.

Fitting the collar


The strap must be adjusted so that the contact points are in contact with the skin of the dog.
Collar adjustment is very important:
- If the strap is too loose, the collar is likely to move and repeated friction can irritate the skin of your dog.
Furthermore, it will not function correctly.
- If the collar is too tight, the dog will have breathing difficulties.
The strap is properly adjusted when you can insert two fingers between the strap and your dog's neck.
Do not leave the collar positioned at the same place for long periods (i.e. over 3 hours) because this can
cause irritations. If your dog must wear the collar for long periods, change regularly the position on the neck
of your dog.
Gb - 29