C Hecking/Replacing Battery Of Remote Control; Checking/Replacing Battery Of Receiver Collar - Num'axes CANICOM Soft Guide D'utilisation

- send a vibration to your dog when it is disobedient,
- draw its attention...
It's very important to always use the vibration in the same way in order not to disturb your dog.
 V V V button: long vibrations
If you press the V V V button, the receiver collar will emit a long vibration. The vibration will last for as long
as the button is pressed (but limited to 8 seconds maximum).
The central indicator light of the remote control will come on for as long as the button is pressed.
It's up to you to use the vibration depending on the way you want to train your dog.
With the vibration you can:
- send a vibration to your dog when it is disobedient,
- draw its attention...
It's very important to always use the vibration in the same way in order not to disturb your dog.

C hecking/replacing battery of remote control


To check the condition of the battery, observe the indicator lights located on the remote control.
If the 5 indicator lights flash quickly 3 times when you press a button, the battery is weak.
Be prepared to replace it.
Replace the old battery with a new one as follows:
- On the back of the remote control, use a coin to remove
the battery cover.
- Remove the old battery.
- Insert the new battery (3-V lithium CR 2032) making
sure the "+" noted on the battery is visible (ref. Diagram 5).
- Put the battery cover back in place and use a coin to close it.
- Check the remote control operates correctly.

Checking/Replacing battery of receiver collar


Diagram 5
Replacing battery of
remote control
NUMAXES guide canicom soft -B.indd 20
Gb - 20
WARNING
Make sure the polarity is correct
"+"
of the battery must be visible
13/06/2017 09:34