Checking/Replacing Battery Of Receiver Collar; Changing The Contact Points; How To Check That Your Canicom 200 Is Functioning Properly; Getting The Best Results - Num'axes CANICOM 200 Guide D'utilisation

Masquer les pouces Voir aussi pour CANICOM 200:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 3

Checking/Replacing battery of receiver collar

To check the condition of the receiver collar battery, observe the On/Off indicator located on the front of
the receiver collar:
• Battery fully charged: flashes slow green.
• Weak battery: flashes quickly red. Replace it with a new battery (See § Fitting the battery in the receiver
collar).
Check the receiver collar operates correctly.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be completely compatible
with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.

Changing the contact points

Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).

How to check that your CANICOM 200 is functioning properly

You can check that your CANICOM 200 is operating correctly at any time.
- Before doing so, make sure that the receiver collar is turned « off ».
- Place the neon test lamp in contact with each of the contact points (by unscrewing them then by
screwing them up in order to grip wires of the lamp under the contact points).
- Turn « on » the remote control and receiver collar.
- Press the « F » or « C » button and modify the level of intensity of the stimulations: the test lamp will
come on with more or less intensity.

Getting the best results

The training instructions you send to your dog are sent from the remote control to the receiver collar by
radio waves. These radio waves are sensitive and the range reaches approximately 200 meters
(depending on geography and environment).
Gb - 27

Publicité

Table des Matières
loading

Table des Matières