Checking/Replacing Battery Of Receiver Collar; Changing The Contact Points; Getting The Best Results - Num'axes Canicom 250 LE Guide D'utilisation

When the battery is empty, you can not use the remote control. If pressing a button, the LED located
on the front of the remote control will not light.

Checking/Replacing battery of receiver collar

To check the condition of the receiver collar battery, observe the indicator light located on the front of the
receiver collar:
• Battery fully charged: flashes slowly green.
• Weak battery: flashes quickly red. Replace it with a new battery 3-V Lithium CR2 (See § Fitting the
battery in the receiver collar). Check the receiver collar operates correctly.

Changing the contact points

Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).
How to check that your product is functioning properly
You can check that your product is operating correctly at any time.
- Before doing so, make sure that the receiver collar is turned « off ».
- Place the neon test lamp in contact with each of the contact points (by unscrewing them then by
screwing them up in order to grip wires of the lamp under the contact points).
- Turn « on » the remote control and receiver collar.
- Press the "1" button then modify the level of intensity of the stimulations by pressing the buttons 2 to 5:
the test lamp must light with more or less intensity.

Getting the best results

The training instructions you send to your dog are sent from the remote control to the receiver collar by
radio waves. These radio waves are sensitive and the range reaches approximately 250 meters
/ 270 yards (depending on geography and environment).
Gb - 22