How To Use The Remote Control - Num'axes CANICOM 300 Expert Guide D'utilisation

Gb - 26

How to use the remote control


The CANICOM 300 Expert remote control is designed to operate with 1 or 2 receiver collars.
Before sending any training instruction (vibration or stimulation), you have to select the dog you want
to send a message to:
Dog A (red strap) or dog B (green strap)
To select the dog you want to train on the remote control, proceed in the following way:
Press the A or B key in order to select the collar (the letter A or B will appear on the LCD screen).
 V Button: Vibration
If you press the V (vibration) button the receiver collar will emit vibrations. There is no time limit for this
function: the collar will continue to vibrate for as long as the button is pressed.
A transmission symbol will appear on the LCD screen of the remote control; the indicator light on the collar
goes from flashing green to permanent green for as long as the button is pressed.
It's up to you to use the vibrations depending on the way you want to train your dog.
With the vibrations you can:
- send a warning to your dog when it is disobedient,
- draw its attention ...
It's very important to always use the vibrations in the same way in order not to disturb your dog.
 F button: Flash stimulation
Press the F button to send a warning to your dog using static stimulations transmitted by the two contact
points located on the receiver collar for a defined length of time of less than one second.
A transmission symbol will appear on the LCD screen of the remote control; the indicator light on the collar
goes from flashing green to permanent green while the stimulations are being sent.
 C button: Continuous stimulation
Press the C button to send a warning to your dog using static stimulations transmitted by the two contact
points located on the receiver collar, this will last for as long as the button is pressed but limited to 8
seconds maximum.
A transmission symbol will appear on the LCD screen of the remote control; the indicator light on the
collar goes from flashing green to permanent green while the stimulations are being sent.
If you press the C button for more than 8 seconds, the collar will automatically go into safety mode for a
few seconds before restarting itself normally.