Checking/Replacing Battery Of Receiver Collar(S); Changing The Contact Points - Num'axes CANICOM 800 Guide D'utilisation

- Remove the old battery(ies).
- Insert the new battery(ies) paying attention to follow polarity indicated on the battery
housing.
- Put the battery cover back in place.
- Retighten the screw.
- Check the remote control operates correctly.
Replacing battery
of CANICOM 800
remote control
Diagram 9

Checking/replacing battery of receiver collar(s)

To check the condition of the receiver collar battery, observe the On/Off indicator located on the front of
the receiver collar:
- Battery fully charged: flashes slow green.
- Weak battery: flashes quickly red. Replace it with a new lithium 3 Volts CR2 battery (See § First
use from new: fitting the battery in the receiver collar).
Check the receiver collar operates correctly.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your

Changing the contact points

new purchased product. Other brands of batteries may not operate, or may not be completely
compatible with your product. You can purchase the suitable batteries from NUM'AXES or from
your distributor.
Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).
Gb - 28
WARNING
Make sure the polarity is correct
Replacing batteries
of CANICOM 1500
remote control
Diagram 10