Connecting The Base Unit; Wall Installation - switel POWERTEL TF 57 Mode D'emploi

Connecting the base unit

Connect the telephone as illustrated in the diagram. Only use the
telephone connection line supplied because the equipment may not
function if another telephone connection line is used.
Mains power
outlet
Only use the power adapter plug supplied labelled with output
data 9 V , 300 mA.
DC
Receiver connection
Telephone line socket
Putting the Telephone into Operation

Wall installation

The telephone can also be installed on a wall. You require two screws in
order to fix the telephone on a wall.
Feed the guide tabs (1) on the wall mounting bracket (2) in the slots (3) on
the rear side of the telephone. Slide the wall bracket (2) 10 mm upwards
until it audibly snaps into place.
Warning: Ensure that there are no cables or pipes etc. under the
wall surface where you want to drill the holes.
Drill two holes whose distance apart corresponds to the bracket to be
used, insert the screws and allow them to project 5 mm from the wall.
Position the telephone on the bracket, fit the screws in the slots and slide
the telephone downwards a little.
Turn the receiver hook (4) in the receiver cradle 180° so that the receiver
can be hooked in.
3 3
1
4
4
2
4
4
4
39