SOUNDMASTER MCD1820 Manuel D'instructions page 26

Encoding bit rate (by remote control)
You can select the desired bit rate for encoding to USB or SD, the selectable range from 32 /
64 / 96 /128 / 192 / 256 kbps.
1. Set in "PHONO/AUX" or "TAPE" function.
2. Press "DELETE / INFO" and the LCD display will show the default bit rate (128 kbps).
3. Press " TUNE –" or "
4. Press again "DELETE / INFO" button to confirm the setting and the LCD display resume to
"Phono/Aux" mode.
File delete at USB / SD card (by remote control)
The system is able to erase the file stored inside the USB pen drive or SD card by following:
1. Insert the media storage and set at "USB" or "SD" mode.
2. Press the "DELETE / INFO" button and the LCD display will show (del ---001).
3. Press " TUNE –" or "
4. Press "DELETE / INFO" to enter "Yes / No" selection and then "
to select "Yes" or "No".
5. With "DELETE / INFO" button, confirm the setting.
Remark :
Press " / ENTER" button once at remote control to quite delete mode.
Removing of USB / memory card
To remove the USB / memory card, turn off the power or switch the function mode to either CD,
Tape or Radio first. For USB port – un-plug it by pulling out the USB socket directly, for memory
card – pull out the SD/MMC card straightly without bending.
General operation
Cassette playback : The system will start the playback automatically after inserting
Stop and ejection
Fast forward
Remark
- Make sure the direction is correct when inserting the tape into the system.
- There is some searching noise can be heard and the system cannot perform normal
playback function during fast forward mode.
- This is recommended to take out the cassette tape from the system every time after
listening and don't leave the cassette tape inside the system when not under playback
mode.
TUNE +" to select the desired bit rate for encoding.
TUNE +" to select the file going to delete.
of cassette tape
: Press the "Tape forward / Eject" button completely inwards
and the cassette tape will be ejected though the cassette door cover. The
"Tape forward / Eject" button will keeping at lowest height position.
: Press the "Tape forward / eject" button half inwards during playback
mode, the tape winding forward direction. The "Tape forward / Eject"
button will keeping at middle height position.
Slightly press the "Tape forward / Eject" button again to resume normal
playback. The "Tape forward / Eject" button will resume to the highest
position.
MCD1820 / English Instruction Manual
TAPE
10
TUNE –" or " TUNE +"