SOUNDMASTER MCD1820 Manuel D'instructions page 23

2. Press the "MEM / MENU" button, "001 PR01" will appear on LCD display.
3. Select a desired track by pressing "
4. Press the "MEM / MENU" button to store the track into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press " " button to play the disc in
assigned order.
7. Press " / ENTER" button to terminate program play.
➢ After programmed the CD tracks and stay at stop mode, press "
" TUNE +" to review the tracks being programmed.
➢ Press " / ENTER" button again at CD stop mode to cancel all programmed memory,
display will appear "PGM CLEAR" few seconds.
➢ For MP3 disc / file, press the "FOLDER / PRESET" button to select the first track of next
folder directly and hence to speed up the song selection.
➢ The programming mode will automatically stop if no button is being pressed in a period of
about 10 seconds after pressing the "MEM / MENU" button.
Remark: There is a bookmark function of the unit under CD & USB/SD playback. When the
device is switched to other function during CD/USB/SD playback, the CD/USB/SD will
automatically resume from the last playback section once it switched back to CD/USB/SD
mode.
Connecting
The system is able to decode and playback all MP3 file which stored in the memory media with
USB connecting port or SD/MMC memory card.
1. Set the system at standby mode first or other function except SD or USB mode.
2. Plug-in the USB pen-drive with the face up & make sure it going into completely or insert the
memory card in the direction of the arrow as shown in the label on the underside of the
memory card slot cover. Insert straight without bending.
⚫ Connecting the USB upside down or backwards could damage the audio system or
the storage media (USB thumb drive / SD/MMC card). Check to be sure the direction
is correct before connection.
3. Press "FUNCTION" button to select "CARD" or "USB" mode.
4. The system will start reading the storage media automatically after connecting, and LCD
display will show the total number of MP3 files being detected.
5. Repeat the same playback procedure as playing CD/MP3 disc as above.
Remark
- The system can detect and read the file under MP3 format only though the USB port.
- If connect the system to MP3 player via the USB socket, due to variances in MP3 encoding
format, some MP3 player may not be able to play via the USB socket. This is not a
malfunction of the system.
- USB port does not support connection with USB extension cable and is not designed for
communication with computer directly.
TUNE –" or "
USB / MICRO SD
7
MCD1820 / English Instruction Manual
TUNE +".
TUNE –" or