SOUNDMASTER MCD1820 Manuel D'instructions page 20

a) Full scan:
Starts the complete station scan. The DAB frequency band is scanned for available stations.
b) Manual tune:
To do so you need to know the station frequency. This can be found on the internet site of
the broadcasting service. Select individual frequencies and confirm with " / ENTER".
c) DRC (Digital Range Control):
The term DRC describes the ratio between the quietest and the loudest sound. If the
dynamic range is very high there are very soft sounds as well as very loud sounds.
Under some circumstances this may present a problem with playback. Let us assume that
you are listening to a radio station in a relatively loud environment. By increasing the volume
you can play the quiet sections louder.
This however has the disadvantage that the loud sections become uncomfortably loud. It
makes sense here to reduce the dynamic range. Select between the options:
DRC off: The dynamic range is not reduced.
DRC high: The dynamic range is sharply reduced.
DRC low: The dynamic range is slightly reduced.
d) Prune:
It may be that you can no longer receive some stations after a station scan or change of
location. With this function you can delete these stations from the reception list. Select "YES"
and confirm with " / ENTER".
e) System:
See under "SYSTEM SETTINGS".
Press "FUNCTION" to select the FM mode.
Automatic station search
Press on the remote control "
"SCAN" to start the search. The unit stops automatically when a station is found.
Manual search
Briefly press " TUNE –" or "
STORE PRESET STATION
Is the same as in DAB mode.
RECALL PRESET STATION
Is the same as in DAB mode.
FM MENU
The device must be in FM mode. Enter the FM menu by pressing the "MEM / MENU" button.
Select with " TUNE –" or "
" / ENTER":
FM
TUNE –" or " TUNE +" to select the search direction. Press
TUNE +" to adjust the frequency in 50kHz steps.
TUNE +" the one of the following settings and confirm with
4
MCD1820 / English Instruction Manual