Equalizer (Eq) - SOUNDMASTER MCD1820 Manuel D'instructions

Noted:
Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone arm rest before operating and re-
-
secured again afterwards.
1. Select the "PHONO/AUX" function.
2. Set the "Speed selector" to the proper position depending on the record to be played.
3. Place the record on the platter (use the spindle adaptor if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The platter will start to
rotate.
5. Place the tone arm to the desired position of the record.
6. At the end of record, the platter will automatically stop rotating. Lift the tone arm from the
record and return it to the rest.
7. To stop manually, lift the tone arm from the record and return it to the rest.
Remark: As some kind of record the auto-stop area was out of the unit setting, so it will stop
before the last track finish. In this case, select the auto-stop switch to "Off" position, then it will
run to the end of the record but will not stop automatically (turn off the unit by power button or
switch back the auto-stop switch to "on" position to stop the platter rotate). Then put back the
tone arm to the rest position.
Sleep setting (by remote control)
1. Press "SLEEP / TIMER" button and sleep indicator "
2. Keep pressing the button to adjust the sleep timer in the order of 90 > 75 >60....15 minutes.
3. System will stop and go to standby mode automatically after the selected timing.
4. To cancel the sleep mode, press "SLEEP / TIMER" until the unit show "off".
Remark:
If press the sleep button once and the sleep indicator "
system will go to standby mode automatically after selected minutes.
This unit provides 5 differences sound mode to enhance your listening experience. You can
select the desired effect by pressing the "EQ" button repeatedly at following sequence:
FLAT
Timer clock setting (by remote control)
This function allows the system to turn on automatically and wake you up by CD, DAB, FM
Radio, USB or SD mode respectively.
First, set the unit in standby mode and then press & hold the "SLEEP / TIMER" button to enter
the setting mode, the LCD display will show "SET TIMER" then change to "SELECT SOURCE"
and the timer " " icon will flash on display:
PHONO
SLEEP

EQUALIZER (EQ)

CLASSIC ROCK
TIMER
11
MCD1820 / English Instruction Manual
" will be shown on the LCD display.
" will appear on the LCD display, the
POP JAZZ