Remote Control - GYS TIG 220 DC Mode D'emploi

REMOTE CONTROL

The remote control operates in TIG mode and in MMA.
ref. 045699
Connection
1- Plug the remote control into the connection at the back of the machine.
2- The machine will detect automatically the remote control and open a selection menu:
Foot pedal selection.
Remote control with potentiometer selection.
CONNECT-5 (automate-robot) selection.
Remote control is connected but inactive.
Connection
The material is equipped with a female socket for a remote control.
The specific 7 pin male plug (option ref. 045699) enables connection to the different types of manual remote control or foot pedal. For the cabling
layout, please see the diagram below.
CONNECT-5
Operating :
• Manual remote control (option ref. 045675) :
The remote control enables the variation of current from 50% to 100% of the set intensity. In this configuration, all modes and functions of the
machine are accessible and can be set.
• Pedal (option ref. 045682) :
The pedal control enables variation of the current from the minimum set current to a 100% of the set intensity.
In TIG mode, the machine will only operate in two-stage welding (2T mode). The upslope and downslope are not automatic, and are controlled by
the User with the foot pedal.
• Connect 5 - automaton mode (TIG 300 DC only) :
This mode enables to pilot the TIG 300 DC from a console or from an automaton due to 5 pre-saved programs.
As the foot pedal, the «Switch (D)» enables to start or stop welding according to the choosen cycle. The voltage value for the «slider (B)» matches
a program or the actual statut.
This voltage must be between 0 and 10V (step of 1.6V) which is linked to a program reminder:
- Actual status : 0 – 1.6 V
- Program 1 : 1.7 – 3.3 V
- Program 2 : 3.4 – 5.0 V
- Program 3 : 5.1 – 6.6 V
- Program 4 : 6.7 – 8.3 V
- Program 5 : 8.4 – 10.0 V
An additional potentiometer enables to change the current (+/- 15%) either whilst welding or not. The information ARC ON (arc presence) enables
the automaton to synchonise itself (Pull Up 100kΩ entry, automaton side). Put the pin AUTO_DETECT to the earth enables to start the product
without going through the window where you can select the type of remote control used.
The 5 programs loaded correspond to the frist 5 saved programs (P1 to P5).
Additional explanations are avialable on our website (https://goo.gl/i146Ma) .
24
TIG 220 DC / 300 DC
G
F
A
B
E
D C
External view
REMOTE CONTROL TYPE
Foot pedal
D
045682
C
B
045675
A
Electric diagram according to remote control type.
Manual remote control
Wire description
10V
Cursor
Common/Earth
Switch
AUTO-DETECT
ARC ON
REG I
EN
Pin
A
B
C
D
E
F
G