Control Interface - GYS AUTOPULSE 220-M3 Mode D'emploi

CONTROL INTERFACE

- The adjusting wheel (1) allows to adjust or to select the parameters of the left window. The adjusting wheel (2) allows to adjust or to select the
parameters of the right window.
- The default unlock code is: 0000
- To update the product or welding parameters, start the machine with a USB stick containing the latest version available (log on to the service section
of the GYS website).
Description of the different interface windows (see next page):
1 Choice of the display mode (Simple, Expert, Advanced).
Simple: Display only the box modes (charts are not accessible)
Expert: Simple display and chart mode, allows to adjust the duration and time of the different phases of the welding cycle, except for additional arc
voltages.
Advanced: Display in Expert mode and additional chart to adjust the different arc voltages.
2 Choice of the main welding parameter (speed, current, thickness).
3 Choice of the welding mode: Manual, Standard, Pulsed, Pulse in Pulse (in the right window).
- Choice of the trigger mode (2T, 4T, Spot, Delay), in the left window.
- Choice of the wire diameter and the couple Material–Gas, in the left window.
4 5 Jobs management windows.
These windows allow to save, to delete and to reload the jobs from the USB key.
6 Window accessible in all display modes (simple, expert, advanced), this window corresponds to a box mode, no chart available.
7 Window accessible in the expert and advanced mode, it allows the setting of the level and the duration of each welding phase.
8 Window accessible only with the advanced mode, it allows the setting of the different arc voltages.
AUTOPULSE 220-M3
EN
27