Servicing Two Speed Winch 14St, 16St - Lewmar 6 Notice D'entretien

Masquer les pouces Voir aussi pour 6:
Table des Matières

Publicité

SERVICING TWO SPEED WINCH 14ST, 16ST

1
4
7
10
Page 36
2
5
8
11
3
6
9
12
1. Unscrew and remove the top cap, lift off the
feeder arm and remove the 2 retaining collets.
2. Lift off the drum.
3. Remove and clean the drum bearings and washer.
4. Remove and clean the gear spindle and gear.
5. To remove the main spindle, rotate it in a
clockwise direction as you lift it, also remove the
ratchet gear.
6. Remove, clean and inspect the pawls and spings,
look for excess wear, replace if necessary.
Lubricate pawls with a light machine oil.
7. Lightly grease the ratchet gear, place it in position
with the ratchet facing up as shown.
8. Re-assemble in reverse order, remember to lightly
grease all gears, ratchet tracks, spindles and
bearings.
9. Remove the three fixing screws holding the crown
assembly to the drum.
10. Carefully lift off the crowns and lift out the springs.
11. Remove, clean and inspect pawls and pawl
springs, look for excess wear, replace as
necessary. Lubricate pawls with a light machine
oil. Re-assemble.
12. To fit the drum, you will need to use a small
bladed screwdriver to close the pawls.
Page 37

Publicité

Table des Matières
loading

Table des Matières